How-To: Repacking your DASA Exhaust

Thank you to SandJunkie for writing this article!

First remove the canister from the bike. Also remove the mid pipe section that is bolted onto the canister. I am assuming your using a Junkie DASA tool for the process...if not then just get the end cap off any old way you can...and we will see you in a couple of hours...

For the Junkie tool, insert the washer into the end cap



Now use your ring pliers to insert the snap ring



It should look like this



Now install the 2 piece Junkie tool



The end cap should pop out like this...use the ground because it seems to work better than a bench top